Q.Which network device serves as the entry and exit point of a network, as all data coming in or going out of a network must first pass through it in order to use routing paths ? (A) Modem (B) Gateway (C) Switch (D) Repeater

When we think about how networks communicate with the outside world, we need a device that can translate, manage, and direct traffic between fundamentally different network environments. This is where the gateway comes into play.

A gateway sits at the boundary of a network, functioning as the critical checkpoint through which all data must pass when moving between your local network and external networks (like the internet or another organizational network). Think of it as the main door of a building—everyone entering or leaving must go through it. But a gateway does more than just pass data through; it actively interprets and converts information between networks that may speak different "languages" (protocols).

The key distinction here lies in what each device actually does:

• Modem converts digital signals to analog (and vice versa) for transmission over telephone lines or cable systems. It's about signal conversion, not routing decisions.
• Switch operates within a single network, directing data between devices on the same local network based on MAC addresses. It doesn't handle traffic going outside the network.
• Repeater simply amplifies or regenerates signals to extend the physical reach of a network. It has no intelligence about routing or protocols. …

The question asks which device takes a signal that has grown weak or distorted after travelling through a cable and gives it a fresh, strong boost to continue its journey. This is a classic problem in networking: signals lose strength (attenuate) as they travel, and beyond a certain distance the data becomes unreadable.

Let’s look at each option.

A Hub is a simple multiport device that connects multiple computers in a network. It works at the physical layer and merely broadcasts every incoming signal to all other ports. It does not regenerate or clean up the signal — it just repeats the electrical signal as-is, including any noise or weakening. So a hub is not the right answer.

An Ethernet Card (also called a Network Interface Card or NIC) is the hardware inside a computer that allows it to connect to a network. It handles the conversion of data into signals for the cable, but it does not sit in the middle of a long cable run to boost a weakened signal. Its job is at the endpoint, not along the path.

A Modem (modulator-demodulator) converts digital signals from a computer into analogue signals for transmission over telephone lines (or cable lines), and vice versa. Its purpose is to bridge different types of media, not to regenerate a weakened signal on the same type of cable. A modem does not amplify or clean up a fading signal in the way the question describes.

The question asks for a networking device that connects computers, uses packet switching, and forwards data to the destination. Let’s think about what this means.

Concept and intuition:

In a network, devices need to communicate by sending data. Early networks used simple devices like hubs, which just broadcast data to all connected devices — inefficient and insecure. Then came bridges, which could filter traffic based on MAC addresses. But the device that truly uses packet switching to intelligently receive and forward data is a switch. A switch examines each incoming data packet, reads its destination address (usually a MAC address in Ethernet networks), and forwards it only to the specific port where the destination device is connected. This is the core of packet switching: breaking data into packets, routing each independently, and reassembling at the destination.

Now, let’s work through the reasoning step by step.

1. Identify the function: The device connects computers in a network. This means it’s a local area network (LAN) device, not something that connects different networks (like a router).

2. Packet switching: The device uses packet switching — data is broken into packets, each containing source and destination addresses. The device reads the destination address and forwards the packet accordingly. This rules out a hub, which simply repeats signals to all ports without any intelligence.

3. Forwarding to destination: The device forwards data specifically to the destination computer, not to all. This requires the device to learn which devices are on which ports (via MAC address learning) and maintain a forwarding table. A switch does exactly this. …