Q.In an a.c. circuit having pure inductor, current

Showing the 12 most recent of 15 on this concept.

1. CBSE 2026Set A1 markMCQ
   Q.Choke coil works on the principle of (A) self induction (B) transient current (C) mutual induction (D) wattless current

   ›Reveal solutionSolution

   A choke coil works on self-induction: its inductance opposes changes in AC current, limiting the current with negligible power loss.

   A choke coil is an inductor of large inductance $L$ and small resistance. In an AC circuit it presents an inductive reactance $X_L = \omega L$, which arises from the back-emf produced by the coil's own changing flux — i.e. self-induction. This reactance limits the current. Because an ideal inductor's current lags the voltage by $90^\circ$, the average power …

   🔒 Start your 14-day free trial to see the full solution →
2. CBSE 2026Set ANNUAL1 markMCQ
   Q.In an a.c. circuit having pure inductor, current

   (a) leads the voltage by an angle of π/2

   (b) leads the voltage by an angle of π

   (c) lags the voltage by an angle of π/2

   (d) lags the voltage by an angle of π

   ›Reveal solutionSolution

   In a pure inductor, the back-emf opposes the change in current, forcing the current to lag 90° behind the applied voltage.

   For a pure inductor with applied voltage $v = v_0\sin(\omega t)$, the induced back-emf balances the applied voltage: $v = L\dfrac{di}{dt}$. Solving,

   $i = \frac{v_0}{\omega L}\int \sin(\omega t)\,dt = -\frac{v_0}{\omega L}\cos(\omega t) = \frac{v_0}{\omega L}\sin\!\left(\omega t - \frac{\pi}{2}\right)$

   …

   🔒 Start your 14-day free trial to see the full solution →
3. CBSE 2025Set 55/6/11 markMCQ
   Q.An ac source is connected to a resistor and an inductor in series. The voltage across the resistor and inductor are 8 V and 6 V respectively. The voltage of the source is: (A) 10 V (B) 12 V (C) 14 V (D) 16 V

   ›Reveal solutionSolution

   In a series RL circuit, the resistor and inductor voltages are 90° out of phase, so the source voltage is the phasor sum (Pythagorean sum) of the two: $\sqrt{8^2 + 6^2} = 10\ \text{V}$. The correct option is (A).

   Concept and Intuition

   When an AC source drives a resistor and an inductor in series, the two components respond differently to the alternating current. The resistor’s voltage is in phase with the current — it rises and falls exactly when the current does. The inductor’s voltage, however, leads the current by 90° (a quarter-cycle ahead). This phase difference means you cannot simply add the two voltages as ordinary numbers (8 V + 6 V = 14 V). That would be a common mistake — it ignores the fact that the peaks of these voltages occur at different times.

   Instead, we treat them as phasors — rotating arrows whose lengths represent the voltage magnitudes and whose angles represent the phase. The resistor voltage points along the reference direction (say, the x-axis), and the inductor voltage points 90° ahead (the y-axis). The source voltage is the vector sum of these two perpendicular phasors. That’s why the Pythagorean theorem gives the answer.

   Watch out

   Never add RMS voltages of different components in an AC circuit as if they were DC voltages. The phase difference (here 90° for a pure inductor) makes the total less than the arithmetic sum. 8 + 6 = 14 V is a trap — the correct answer is 10 V.

   Step-by-Step Solution

   1. Identify the given data.

      Voltage across resistor: $V_R = 8\ \text{V}$ (RMS value).

      Voltage across inductor: $V_L = 6\ \text{V}$ (RMS value).

      The circuit is a series RL combination connected to an AC source.

   2. Recall the phase relationship.

      In a series RL circuit, the current $I$ is the same through both components.

      • For the resistor: $V_R = I R$, and $V_R$ is in phase with $I$.
      • For the inductor: $V_L = I X_L$, and $V_L$ leads $I$ by $90^\circ$. …

   🔒 Start your 14-day free trial to see the full solution →
4. CBSE 2025Set D1 markMCQ
   Q.In a purely inductive circuit, the power factor is (A) 0 (B) 1 (C) 0.5 (D) infinity

   ›Reveal solutionSolution

   In a pure inductor current lags voltage by 90°, so power factor cos φ = cos 90° = 0 (no average power consumed).

   In a purely inductive a.c. circuit, the current lags the applied voltage by a phase angle of 90° (φ = 90°).

   The power factor is

   $\cos\phi = \cos 90^\circ = 0$

   …

   🔒 Start your 14-day free trial to see the full solution →
5. CBSE 2025Set ANNUAL1 mark
   Q.In a purely inductive a.c. circuit the alternating current lags behind the alternating voltage by ____________ phase angle.

   ›Reveal solutionSolution

   In a purely inductive circuit, the back-EMF from the inductor makes the current reach its peak a quarter-cycle after the voltage — a 90 degree phase lag.

   For a purely inductive AC circuit with applied voltage $V = V_0\sin\omega t$, the current is:

   $I = \dfrac{V_0}{\omega L}\sin\left(\omega t - \dfrac{\pi}{2}\right)$

   …

   🔒 Start your 14-day free trial to see the full solution →
6. CBSE 2023Set B1 mark
   Q.Fill in the blank: The ohmic resistance of an ideal inductance is ______.

   ›Reveal solutionSolution

   An ideal inductor is made of resistance-less wire, so its DC/ohmic resistance is zero; it opposes AC only through inductive reactance $X_L=\omega L$.

   An 'ideal inductance' is an idealised coil that has inductance but is assumed to be wound from a perfect (zero-resistance) conductor. It therefore has zero ohmic resistance — it does not dissipate energy as heat ($I^2R$ loss = 0). Its opposition to alternating current comes entirely from the induced back-emf, characterised by the inductive reactance $X_L = \omega L = 2\pi f L$, not from resistance. In …

   🔒 Start your 14-day free trial to see the full solution →
7. CBSE 2023Set ANNUAL1 mark
   Q.What is inductive reactance? Write its SI unit.

   ›Reveal solutionSolution

   Inductive reactance $X_L=\omega L$ measures how strongly a pure inductor opposes AC flow; unlike resistance it depends on frequency and vanishes for DC.

   When a pure inductor of self-inductance $L$ carries an alternating current $i = i_0\sin\omega t$, it develops a self-induced back emf $e=-L\dfrac{di}{dt}$ that opposes the applied voltage. For the source voltage $v=v_0\sin\omega t$ to drive this current, the peak values are related by

   $v_0 = i_0\,\omega L$

   Comparing this with Ohm's law form $v_0=i_0R$, the quantity $\omega L$ plays the role of an 'AC resistance' for the inductor and is called inductive reactance:

   $X_L=\omega L = 2\pi f L$

   where $f$ is the frequency of the AC supply and $L$ is in henry (H).

   …

   🔒 Start your 14-day free trial to see the full solution →
8. CBSE 2022Set I1 markMCQ
   Q.Inductive reactance is (A) X_L = 2πfL (B) X_L = 2πf^2 L (C) X_L = 2πfL^2 (D) X_L = 2πf^2 L^2

   ›Reveal solutionSolution

   Inductive reactance $X_L = \omega L = 2\pi f L$.

   For an inductor of inductance $L$ in an AC circuit of frequency $f$ (angular frequency $\omega = 2\pi f$), the opposition it offers to the alternating current is the inductive reactance:

   $X_L = \omega L = 2\pi f L.$

   …

   🔒 Start your 14-day free trial to see the full solution →
9. CBSE 2022Set TERM21 markMCQ
   Q.Dimensional formula for inductive reactance is:

   (a) ML²T⁻²A⁻³

   (b) ML²T⁻²A⁻²

   (c) ML²T⁻³A⁻²

   (d) ML⁻²T⁻²A⁻¹

   ›Reveal solutionSolution

   Inductive reactance $X_L=\omega L$ has the same units as resistance (Ohm), since $V=I X_L$.

   Inductive reactance is defined by $X_L = \omega L$, and it appears in $V = I X_L$ (Ohm's-law-like relation for an inductor), so it must carry the same dimensions as resistance $R = V/I$.

   Voltage: $[V] = [ML^2T^{-3}A^{-1}]$ …

   🔒 Start your 14-day free trial to see the full solution →
10. CBSE 2021Set A1 markMCQ
    Q.Inductive reactance offered by an inductor of inductance L in ac circuit of angular frequency ω is (A) ω/L (B) ω . L (C) 1/ω.L (D) L/ω

    ›Reveal solutionSolution

    Inductive reactance X_L = ωL.

    An inductor opposes changes in current in an ac circuit. This opposition, called inductive reactance, is:

    $X_L = \omega L = 2\pi f L$

    …

    🔒 Start your 14-day free trial to see the full solution →
11. CBSE 2020Set HE8211 mark
    Q.Fill in the blank: S.I. unit of inductive reactance (Xₗ) is ______.

    ›Reveal solutionSolution

    Inductive reactance has the same unit as resistance: ohm.

    Inductive reactance is defined as $X_L = \omega L = 2\pi f L$, where L is inductance (henry) and ω/f is angular/linear frequency. Since $X_L = V/I$ (from Ohm's-law-like be …

    🔒 Start your 14-day free trial to see the full solution →
12. CBSE 2020Set ANNUAL1 mark
    Q.In a purely inductive AC circuit, the current leads the e.m.f. by phase π/2. (Write 'True' or 'False'.)

    ›Reveal solutionSolution

    The statement is False: in a purely inductive circuit, current lags voltage by π/2 (not leads).

    For a purely inductive AC circuit with e.m.f. $\varepsilon = \varepsilon_0 \sin\omega t$, the induced back e.m.f. across the inductor must balance the applied e.m.f., giving:

    $L\frac{di}{dt} = \varepsilon_0 \sin\omega t$

    Integrating:

    $i = \frac{\varepsilon_0}{\omega L}\left(-\cos\omega t\right) = \frac{\varepsilon_0}{\omega L}\sin\left(\omega t - \frac{\pi}{2}\right)$

    …

    🔒 Start your 14-day free trial to see the full solution →