Beats Frequency Analysis
The Intuition: When Two Tones "Wobble"
Imagine you're tuning a guitar. You pluck the string you're tuning, and at the same time, you play a reference note from a tuning fork. If the two notes are exactly the same pitch, you hear a single steady tone. But if they are slightly different — say one is 440 Hz and the other is 442 Hz — you don't hear two separate notes. Instead, you hear a single tone that wobbles in loudness: it gets louder, then softer, then louder again, in a slow, rhythmic pulse.
That pulse is called a beat. The phenomenon is beats.
Why does this happen? Because the two sound waves are constantly going in and out of sync. When their crests align, they add up to a louder sound (constructive interference). When a crest meets a trough, they cancel partially (destructive interference). The result is a wave whose amplitude rises and falls at a rate equal to the difference between the two original frequencies.
You don't hear the individual frequencies when they are very close. Your ear perceives the average frequency (around 441 Hz in the example), but the loudness fluctuates at the beat frequency.
The Precise Statement
Let two sound waves of slightly different frequencies f1 and f2 (with f1>f2) travel through the same medium. Their displacements at a point can be written as:
y1=Asin(2πf1t)
y2=Asin(2πf2t)
By the principle of superposition, the resultant displacement is:
y=y1+y2=A[sin(2πf1t)+sin(2πf2t)]
Using the trigonometric identity sinP+sinQ=2sin(2P+Q)cos(2P−Q), we get:
y=2Acos(2π2f1−f2t)sin(2π2f1+f2t)
This is the key equation. It describes a wave with two parts:
- The carrier wave: sin(2π2f1+f2t) — this oscillates at the average frequency favg=2f1+f2. This is the pitch you actually hear.
- The envelope: 2Acos(2π2f1−f2t) — this modulates the amplitude of the carrier. The envelope oscillates at half the difference frequency.
Beat Frequency:
fbeat=∣f1−f2∣
This is the number of loudness maxima (or minima) you hear per second.
Why ∣f1−f2∣ and not half of it? Because the cosine term goes through a full cycle (from maximum to minimum and back to maximum) when its argument changes by 2π. That happens when 2f1−f2t=1, i.e., t=f1−f22. So the time period of the envelope is Tenvelope=∣f1−f2∣2. But the loudness (intensity) goes through two maxima per envelope cycle — one at each positive peak of the cosine and one at each negative peak (since squaring the amplitude gives intensity). So the period of the beat (the time between successive loudness maxima) is half of that: Tbeat=∣f1−f2∣1. Hence, the beat frequency is fbeat=Tbeat1=∣f1−f2∣.
A common mistake is to think the beat frequency is 2∣f1−f2∣. That is the frequency of the envelope oscillation, not the beat. The ear detects two loudness peaks per envelope cycle, so the beat frequency is double the envelope frequency.
Key Conditions for Beats
- Small difference: The two frequencies must be close (typically less than about 10–15 Hz apart). If the difference is too large, the ear perceives two separate tones instead of beats.
- Comparable amplitudes: The amplitudes should be roughly equal for maximum contrast in loudness. If one is much louder, beats are still present but less noticeable.
- Same medium: The waves must overlap in the same region of space.
Why This Matters for Exams …