Q.Explain why
You're viewing a preview — the full solution, concept, methods & PYQ mapping are locked.
Start your 14-day free trial to unlock the full solution →All five phenomena are explained by Bernoulli’s principle: where fluid speed is higher, pressure is lower. The pressure differences create net forces that cause the observed effects — from paper lifting to curved cricket balls.
Let’s take each case one by one, building the physics from the ground up.
(a) To keep a piece of paper horizontal, you should blow over, not under, it.
Concept: Bernoulli’s principle says that in a moving fluid, faster flow means lower pressure. When you blow air over the top of a paper strip, the air speed above is much higher than the still air below. This creates a pressure difference: lower pressure above, higher pressure below. The net upward force lifts the paper.
If you blew under the paper, the fast-moving air below would create low pressure there, and the still air above would push the paper down — making it sag or fall.
Many students think blowing under the paper would lift it, like a leaf blower. But Bernoulli’s principle shows the opposite: fast air below = low pressure below = paper gets pushed downward by the higher pressure above.
Step-by-step:
- Identify the two regions: Above the paper (where you blow) and below (still air).
- Apply Bernoulli: . Since , we get .
- Net force: Pressure difference acts upward over the paper’s area, lifting it.
Try it with a strip of paper held just below your lips. Blow horizontally across the top — the paper rises. That’s Bernoulli in action, not magic.
(b) When we try to close a water tap with our fingers, fast jets of water gush through the openings between our fingers.
Concept: As you press your fingers against the tap opening, you reduce the area available for water to flow. For a given flow rate (volume per second), a smaller cross-sectional area forces the water speed to increase dramatically — by the continuity equation . The high-speed water then has low pressure (Bernoulli), so it doesn’t spread out; instead, it forms narrow, fast jets that shoot through the gaps.
Step-by-step:
- Continuity equation: The tap supplies water at a roughly constant volume flow rate . If you block most of the opening, the remaining gaps have total area . So becomes very large.
- Bernoulli’s effect: High speed in the gaps means low pressure there. The surrounding atmospheric pressure is higher, so the jet stays narrow and doesn’t spread — it shoots out as a fast stream.
- Why it feels forceful: The momentum of the fast water (mass × high velocity) delivers a strong impulse per second, making the jets feel like they’re “gushing.”
Don’t confuse this with “squeezing” the water. The water isn’t being compressed — it’s just speeding up because the same flow is forced through a smaller opening.
(c) The size of the needle of a syringe controls flow rate better than the thumb pressure exerted by a doctor while administering an injection.
Concept: Flow through a narrow tube (like a needle) is governed by Poiseuille’s law for viscous fluids: . The flow rate depends on the fourth power of the needle’s radius . Halving the radius reduces flow by a factor of 16 — a huge change. In contrast, thumb pressure appears only linearly, so doubling the pressure only doubles the flow. The needle’s size is therefore the dominant control.
Step-by-step:
- Poiseuille’s law: For laminar flow of a viscous fluid through a cylindrical tube,
where = radius, = pressure difference, = viscosity, = length.
2. Compare sensitivities:
- Changing : — a tiny change in radius has a massive effect.
- Changing : — linear, much weaker.
- Practical implication: A doctor’s thumb can vary pressure only within a limited range (say 2× to 3×), but switching from a 22-gauge needle to a 26-gauge needle (smaller radius) can reduce flow by over 90%. So needle size is the real flow controller.
Flow rate is proportional to the fourth power of the radius — the needle’s size dominates.
This is why insulin syringes have very fine needles: they deliver tiny, precise doses even with gentle thumb pressure.
(d) A fluid flowing out of a small hole in a vessel results in a backward thrust on the vessel.
Concept: This is Newton’s third law in action — the same principle that makes a rocket or a fire hose recoil. As fluid is ejected backward (relative to the vessel), the vessel experiences an equal and opposite forward force. But here, the fluid exits through a small hole, so the jet’s momentum change creates a reaction force on the vessel.
Step-by-step: …
Unlock everything free for 14 days
- Full step-by-step solutions
- Concept-first explanations
- Methods, shortcuts & mistakes
- PYQ mapping + timed mock tests
Full access for 14 days. No credit card required.