Q.The processes involved in muscle contraction are given below. Arrange them in correct sequential order. (The first step is given correct)
• A signal sent out by CNS.
• Binding of Ca++ with troponin.
• Release of a neurotransmitter.
• Remove the masking of active sites for myosin.
• Release of Ca++ into Sarcoplasm.

Mechanism Of Muscle Contraction

You are sitting still, reading this. Now clench your fist. In that instant, a signal shot from your brain down your arm, crossed a tiny gap onto a muscle fibre, and triggered a microscopic ratcheting motion inside thousands of cells. That ratcheting is muscle contraction.

The whole process is a chain of events that converts a chemical signal (nerve impulse) into a mechanical pull (shortening of the muscle). Let's walk through it step by step, from the nerve ending to the sliding filaments.

Step 1: The nerve impulse arrives and releases acetylcholine

A motor neuron carries an electrical signal to the neuromuscular junction — the point where the nerve meets the muscle fibre. When the impulse reaches the nerve terminal, it triggers the release of a chemical messenger called acetylcholine into the tiny gap (synaptic cleft).

Acetylcholine diffuses across and binds to receptors on the muscle cell membrane. This binding opens ion channels, causing a local electrical change that spreads across the muscle fibre's surface and deep into its interior via tube-like invaginations called T-tubules.

Step 2: The T-tubule signal releases calcium from the sarcoplasmic reticulum

The electrical signal travelling down the T-tubules reaches the sarcoplasmic reticulum (SR) — a specialised calcium store wrapped around each contractile unit. The signal causes calcium channels on the SR to open, and calcium ions (Ca²⁺) flood into the cytoplasm surrounding the myofibrils.

This rise in calcium concentration is the master switch for contraction. Without calcium, the muscle stays relaxed.

Step 3: Calcium exposes the binding sites on actin

Inside each muscle fibre are two key protein filaments: actin (thin) and myosin (thick). In a relaxed muscle, a protein complex called troponin-tropomyosin sits on the actin filament, physically blocking the sites where myosin would attach.

Calcium binds to troponin, which changes shape and shifts the tropomyosin strand away, uncovering the myosin-binding sites on actin. Now the stage is set for the actual pulling.

Step 4: Cross-bridge cycling — the power stroke

Myosin heads are already "cocked" (energised) from a previous ATP hydrolysis. Each myosin head now binds to an exposed site on actin, forming a cross-bridge.

The myosin head then pivots, pulling the actin filament toward the centre of the sarcomere. This is the power stroke — the actual shortening of the muscle. After the power stroke, the myosin head is still attached to actin but in a low-energy position.

Step 5: ATP detaches the myosin and re-cocks it

For the cycle to repeat, the myosin head must let go of actin. A new molecule of ATP binds to the myosin head. This binding causes the myosin to release actin.

The ATP is then hydrolysed (split) into ADP and inorganic phosphate (Pᵢ), and the energy released re-cocks the myosin head back to its high-energy position. The head is now ready to bind to a new actin site further along the filament.

As long as calcium remains high and ATP is available, this cycle repeats hundreds of times per second, sliding the filaments past each other and shortening the muscle.

Step 6: Relaxation — calcium is pumped back

When the nerve signal stops, calcium channels on the SR close. An active calcium pump (using ATP) pumps Ca²⁺ back into the SR, lowering the cytoplasmic calcium level.

Without calcium, troponin returns to its original shape, tropomyosin slides back over the binding sites, and myosin can no longer attach. The muscle relaxes.

The big picture: what drives it all …