Q.What are isotonic and hypertonic solutions?

Showing the 12 most recent of 36 on this concept.

1. CBSE 2026Set DZ1 markMCQ
   Q.Which formula is used to calculate osmotic pressure?

   (a) $\pi = CRT$

   (b) $\pi = VRT$

   (c) $\pi = PVT$

   (d) $\pi = nRT$

   ›Reveal solutionSolution

   Osmotic pressure is a colligative property given by $\pi = CRT$, so option (a) is correct.

   Osmotic pressure ($\pi$) is the extra pressure that must be applied on the solution side of a semipermeable membrane to just stop the net flow of solvent into the solution. For a dilute solution it depends only on the number of solute particles per unit volume, i.e. the molar concentration $C = n/V$.

   The van't Hoff equation for osmotic pressure is:

   $\pi = CRT = \dfrac{n}{V}RT$

   where $C$ = molar concentration (mol L$^{-1}$), $R$ = gas constant, $T$ = absolute temperature. This resembles the ideal-gas equation because both depend on the concentration of particles.

   Checking the options: $\pi = VRT$, $\pi = PVT$ and $\pi = nRT$ are dimensionally/physically wrong (osmotic pressure cannot equal $nRT$ without dividing by volume).

   ✓Final answer

   (a) $\pi = CRT$.

2. CBSE 2026Set ANNUAL1 markMCQ
   Q.Isotonic solutions have the same:

   (a) Normality

   (b) Molarity

   (c) Osmotic pressure

   (d) Formality

   ›Reveal solutionSolution

   Isotonic solutions have equal osmotic pressure, which is why cells neither swell nor shrink when placed in an isotonic medium.

   Osmotic pressure (π) of a solution is given by π = CRT, where C is the molar concentration of solute particles. Two solutions are said to be isotonic with respect to each other when they exhibit the SAME osmotic pressure at the same temperature. When such solutions are separated by a semipermeable membrane, there is no net flow of solvent from one to the other — this is why isotonic saline (0.9% NaCl) is used for intravenous drips, since it matches the osmotic pressure of blood plasma and doesn't cause red blood cells to swell (hypotonic) or shrink (hypertonic).

   Normality and Molarity concern the concentration of solute in terms of equivalents/moles per litre and do not by themselves guarantee equal osmotic pressure (different solutes at the same molarity can dissociate to different extents, e.g. NaCl vs glucose), and "formality" is simply an alternative way of expressing concentration of ionic solids, similarly not the defining criterion for isotonicity.

   ✓Final answer

   (c) Osmotic pressure — by definition, isotonic solutions have equal osmotic pressure.

3. CBSE 2026Set ANNUAL1 markMCQ
   Q.A plant cell shrinks when it is kept in a

   (a) Hypotonic solution

   (b) Hypertonic solution

   (c) Isotonic solution

   (d) Pure water

   ›Reveal solutionSolution

   A plant cell placed in a hypertonic solution loses water to its surroundings by osmosis and shrinks; this is called plasmolysis.

   A solution is hypertonic relative to the cell sap if it has a higher solute concentration (higher osmotic pressure) than the cell's interior. Water always moves from a region of lower solute concentration (higher water potential) to higher solute concentration (lower water potential) across the semi-permeable cell membrane.

   • In a hypotonic solution, water enters the cell, making it swell (and possibly burst in an animal cell, though a plant cell becomes turgid due to its wall).

   • In an isotonic solution, there is no net movement of water.

   • In a hypertonic solution, water leaves the cell, causing the protoplasm to shrink away from the cell wall - this is plasmolysis.

   ✓Final answer

   (b) Hypertonic solution.

4. CBSE 2026Set ANNUAL1 markMCQ
   Q.Sea water is converted into fresh water based upon the phenomenon of:

   (a) Diffusion

   (b) Osmosis

   (c) Plasmolysis

   (d) Reverse Osmosis

   ›Reveal solutionSolution

   Desalination of sea water to get fresh water uses reverse osmosis.

   In normal osmosis, solvent flows from a dilute solution to a concentrated solution through a semipermeable membrane. If a pressure greater than the osmotic pressure of the sea water is applied on the sea-water side, the flow of solvent is reversed — pure water is forced from the concentrated (saline) side through the membrane to the dilute side, leaving the salts behind. This process, reverse osmosis, is the principle used in desalination plants to convert sea water into fresh, potable water.

   ✓Final answer

   (d) Reverse Osmosis.

5. CBSE 2026Set ANNUAL1 markMCQ
   Q.The pressure of solution that just prevents the flow of solvent is called:

   (a) Vapour Pressure

   (b) Osmotic Pressure

   (c) Partial Pressure

   (d) Gas pressure

   ›Reveal solutionSolution

   The pressure that just stops solvent flow (osmosis) is the osmotic pressure.

   When a solution is separated from pure solvent by a semipermeable membrane, solvent flows into the solution (osmosis). The excess pressure that must be applied on the solution side to just prevent this net inflow of solvent is called the osmotic pressure. It is a colligative property, given by pi = CRT (van't Hoff equation).

   ✓Final answer

   (b) Osmotic Pressure.

6. CBSE 2025Set D1 markMCQ
   Q.Isotonic solutions have equal

   (a) osmotic pressure

   (b) vapour pressure

   (c) relative lowering of vapour pressure

   (d) elevation of boiling point

   ›Reveal solutionSolution

   Isotonic solutions have equal osmotic pressure.

   By definition, two solutions are isotonic if they exert the same osmotic pressure at the same temperature. Because osmotic pressure pi = C R T, isotonic solutions must have the same molar concentration of particles.

   If two solutions are isotonic, there is no net movement of solvent across a semipermeable membrane between them.

   ✓Final answer

   (a) osmotic pressure.

7. CBSE 2025Set ANNUAL1 markMCQ
   Q.The porous membrane used in reverse osmosis plant is made up by:

   (a) Cellulose acetone

   (b) Potassium nitrate

   (c) Mercuric iodide

   (d) Starch

   ›Reveal solutionSolution

   The semi-permeable membrane used in reverse osmosis water purification plants is made of cellulose acetate.

   In reverse osmosis, a pressure greater than the osmotic pressure of the solution (e.g. seawater) is applied on the solution side, forcing pure solvent (water) to flow through a semi-permeable membrane from the concentrated to the dilute side — the reverse of normal osmosis. The membrane commonly used for this purpose in desalination/purification plants is made of cellulose acetate — a synthetic semi-permeable membrane that allows water molecules to pass through but rejects dissolved salts. (Option (a) in this paper prints it as "cellulose acetone", which is a typographical slip for cellulose acetate.)

   ✓Final answer

   (a) Cellulose acetate

8. CBSE 2025Set ANNUAL1 markMCQ
   Q.Which of the following colligative properties is used to determine molar masses of proteins, polymers or other macromolecules?

   (a) Depression in freezing point

   (b) Relative lowering of vapour pressure

   (c) Osmotic pressure

   (d) Elevation in boiling point

   ›Reveal solutionSolution

   Colligative properties are inversely proportional to molar mass, so for very large molecules (proteins, polymers) most of them become too small to measure precisely — except osmotic pressure, which stays measurable even in very dilute solutions.

   Why the other options fail

   • (a) Depression in freezing point $\Delta T_f = K_f m$ and (d) Elevation in boiling point $\Delta T_b = K_b m$: for a macromolecule of large $M$, the molality $m = \dfrac{w_2 \times 1000}{M \times w_1}$ is tiny, so $\Delta T_f$/$\Delta T_b$ become too small (often a few thousandths of a kelvin) to measure accurately with an ordinary thermometer.

   • (b) Relative lowering of vapour pressure $\dfrac{p_1^\circ - p_1}{p_1^\circ} = x_2$ also becomes vanishingly small and is experimentally hard to measure with the needed precision for dilute macromolecular solutions.

   • (c) Osmotic pressure $\pi = \dfrac{n_2}{V}RT = CRT$ is directly proportional to molar concentration but is a comparatively LARGE, easily-measurable quantity (of the order of atmospheres) even for very dilute solutions, because of the factor $RT$. This makes it the preferred method experimentally.

   ✓Final answer

   (c) Osmotic pressure — because it remains large enough to measure accurately even in the very dilute solutions typical of proteins and polymers.

9. CBSE 2025Set ANNUAL1 mark
   Q.What are hypertonic solutions?

   ›Reveal solutionSolution

   A hypertonic solution has a greater osmotic pressure (higher effective solute concentration) than a reference solution, so it draws water out of a cell placed in it.

   Definition

   When two solutions are compared, the one with the higher osmotic pressure (i.e. higher concentration of osmotically active solute particles) is called the hypertonic solution relative to the other (which is then called hypotonic).

   If a biological cell (or any solution enclosed by a semi-permeable membrane) is placed in a hypertonic solution, the solvent (water) flows out of the cell (from the region of lower solute concentration/osmotic pressure inside the cell to the higher one outside), through osmosis, causing the cell to shrink — called plasmolysis in plant cells or crenation in animal cells (e.g. red blood cells shrivel in a hypertonic saline solution).

   ✓Final answer

   A hypertonic solution has a higher osmotic pressure than the solution it is compared with; a cell placed in it loses water and shrinks.

10. CBSE 2024Set D1 markMCQ
    Q.Isotonic solutions have the same

    (a) Density

    (b) Normality

    (c) Strength

    (d) Molar concentration

    ›Reveal solutionSolution

    Isotonic solutions have the same osmotic pressure. Since osmotic pressure pi = CRT, equal pi at the same temperature means equal molar concentration C.

    Osmotic pressure of a dilute solution: pi = CRT, where C is molar concentration, R the gas constant and T the temperature.

    Two solutions are isotonic when they have equal osmotic pressures. At the same temperature this requires the same molar concentration of solute particles. (They need not have the same density, normality or mass strength.)

    ✓Final answer

    (D) Molar concentration.

11. CBSE 2024Set D1 markMCQ
    Q.The osmotic pressure of a solution is represented by which of the following equations?

    (a) pi = CR/T

    (b) pi/C = RT

    (c) pi = CT/R

    (d) pi = RT/C

    ›Reveal solutionSolution

    Osmotic pressure: pi = CRT, i.e. pi/C = RT.

    For a dilute solution the osmotic pressure (pi) is given by the van't Hoff equation:

    pi = CRT

    where C is the molar concentration (n/V), R is the gas constant and T is the absolute temperature. Rearranging gives pi/C = RT, which matches option (b). The other options do not reproduce pi = CRT.

    ✓Final answer

    (b) pi/C = RT — the rearranged form of pi = CRT.

12. CBSE 2024Set ANNUAL1 mark
    Q.The two solutions with equal osmotic pressure are called ______.

    ›Reveal solutionSolution

    Two solutions having equal osmotic pressure at a given temperature are called isotonic solutions.

    Osmotic pressure (pi) is the colligative property that measures the pressure needed to stop the net flow of solvent across a semipermeable membrane. If two solutions have exactly the same osmotic pressure at the same temperature, no net osmosis occurs when they are separated by a semipermeable membrane and placed in contact - such solutions are called isotonic solutions.

    If one solution has a higher osmotic pressure than the other, it is called hypertonic with respect to the other, and the one with the lower osmotic pressure is called hypotonic. This concept is important biologically - e.g. a 0.9% NaCl (normal saline) solution is isotonic with human blood plasma, which is why it is used in intravenous drips instead of pure water (which would be hypotonic and cause blood cells to swell and burst).

    ✓Final answer

    Isotonic solutions.