Explain the Young's double slit experimental setup and obtain the equation for path difference.

Long Answer Questions · Q15

Q. Explain the Young's double slit experimental setup and obtain the equation for path difference.

Puducherry TnboardTextbookSubjectiveImportance★★★★★

33% · 65/199 Questions

🔒 Locked · start free trial →

You're viewing a preview — the full solution, concept, methods & PYQ mapping are locked.

Start your 14-day free trial to unlock the full solution →

Concept understanding — Double Slit Interference

Double Slit Interference: From Ripples to Light

Imagine dropping two stones into a still pond at the same time, a short distance apart. Watch the ripples spread. Where a crest from one stone meets a crest from the other, the water rises higher. Where a crest meets a trough, the water flattens out. That is interference — waves adding or cancelling.

Now replace the water with light. Replace the stones with two narrow slits cut into a barrier. Shine a single colour of light (say, red laser light) onto the slits. On a screen behind the barrier, you do not see two bright spots. Instead, you see a pattern of alternating bright and dark bands — like a striped zebra crossing made of light.

That pattern is double slit interference. It is the single most convincing proof that light behaves as a wave.

The Core Idea

Light from a single source passes through two narrow slits. Each slit acts as a new source of waves. These two sets of waves spread out and overlap. At any point on the screen, the light you see is the sum of the waves from slit 1 and slit 2.

Whether they add (bright) or cancel (dark) depends on one thing: the path difference — how much farther one wave has travelled compared to the other.

Note

For constructive interference (bright band): path difference = $n\lambda$ (whole number of wavelengths)

For destructive interference (dark band): path difference = $(n + \frac12)\lambda$ (half-integer number of wavelengths)

Here $\lambda$ is the wavelength of the light, and $n = 0, 1, 2, \dots$

The Geometry

Let the slits be separated by distance $d$ . The screen is far away at distance $D$ ( $D \gg d$ ). For a point on the screen at angle $\theta$ from the centre:

The path difference $\Delta x = d \sin\theta$
Bright bands occur when $d \sin\theta = n\lambda$
Dark bands occur when $d \sin\theta = (n + \frac12)\lambda$

The position $y$ of the $n$ -th bright band on the screen (measured from the centre) is:

y_n = \frac{n\lambda D}{d}

The spacing between consecutive bright bands (fringe width) is:

\beta = \frac{\lambda D}{d}

\text{Fringe width } \beta = \frac{\lambda D}{d}

What This Tells You

Larger $\lambda$ → wider fringes (red light spreads more than blue)
Larger $D$ → wider fringes (screen further away spreads the pattern)
Smaller $d$ → wider fringes (slits closer together spread the pattern more)

If you cover one slit, the pattern vanishes — you get a single blurry blob. The stripes only appear when both slits are open, proving that the light from the two slits is interfering.

Why It Matters

Double slit interference is not a classroom toy. It is the foundation of:

Young's experiment (1801) — which settled the debate: light is a wave
Diffraction gratings — used in spectrometers to identify elements by their light …

Why this formula?

Double Slit Interference: Why the Formula Holds

Let's build the understanding from first principles — not just memorise the formula, but see why it must be true.

1. The Core Idea: Path Difference Creates Phase Difference

Imagine two narrow slits $S_1$ and $S_2$ , separated by distance $d$ , illuminated by a single coherent source. Light from each slit travels to a point $P$ on a screen at distance $D$ (where $D \gg d$ ).

The two waves start in phase at the slits (same source).
They travel different distances to reach $P$ .
This path difference $\Delta x$ causes a phase difference $\Delta \phi$ .

Key relation:

\Delta \phi = \frac{2\pi}{\lambda} \cdot \Delta x

Why? Because one full wavelength $\lambda$ corresponds to a phase change of $2\pi$ radians.

2. Finding the Path Difference

From the geometry (see diagram in any textbook):

For a point $P$ at angle $\theta$ from the central axis, the extra distance travelled by the wave from the farther slit is approximately:

\Delta x = d \sin\theta

Why approximate? Because we assume $D \gg d$ , so the two paths are nearly parallel. This is the Fraunhofer (far-field) approximation — valid for most exam setups.

3. Condition for Constructive Interference (Bright Fringes)

Waves interfere constructively when they arrive in phase:

\Delta \phi = 2\pi m \quad (m = 0, \pm1, \pm2, \dots)

Using $\Delta \phi = \frac{2\pi}{\lambda} \cdot d\sin\theta$ , we get:

\frac{2\pi}{\lambda} \cdot d\sin\theta = 2\pi m

Cancel $2\pi$ to obtain the bright fringe condition:

\boxed{d \sin\theta = m\lambda}

$m$ is called the order of the fringe.
$m=0$ gives the central bright fringe (straight ahead).

4. Condition for Destructive Interference (Dark Fringes)

Waves interfere destructively when they arrive out of phase by $\pi$ (half a cycle):

\Delta \phi = (2m+1)\pi

Substitute again:

\frac{2\pi}{\lambda} \cdot d\sin\theta = (2m+1)\pi

Cancel $\pi$ to get the dark fringe condition:

\boxed{d \sin\theta = \left(m + \frac12\right)\lambda}

5. From Angle to Position on Screen

For small angles (typical in exam problems), $\sin\theta \approx \tan\theta = \frac{y}{D}$ , where $y$ is the distance from the central maximum on the screen.

Bright fringe position:

y_m = \frac{m\lambda D}{d}

Dark fringe position:

$y_m = \frac{(m + \frac12)\lambda D}{d}$ …

Start your 14-day free trial to unlock the full solution →

Step 1. A single source $S$ illuminates two slits $S_1,S_2$ (separation $d$ ), both equidistant from $S$ (so both are fed exactly in phase); a screen is placed parallel to the double slit at distance $D$ . Let $C$ be the midpoint of $S_1S_2$ , $O$ the corresponding midpoint on the screen, and $P$ a general screen point at height $y$ from $O$ .

Step 2. The path difference at $P$ is $\delta=S_2P-S_1P$ . Dropping a perpendicular from $S_1$ onto the line $S_2P$ , meeting it at $M$ , gives $S_1P=MP$ (approximately, for $D\gg d$ ), so $\delta=S_2P-MP=S_2M$ .

Step 3. In the right triangle $\triangle S_1S_2M$ , $S_2M=d\sin\theta$ , where $\theta$ is the angular position of $P$ from $C$ (using the fact that $\angle OCP=\angle S_2S_1M=\theta$ , both being the angle the line to $P$ makes with the axis). So $\boxed{\delta=d\sin\theta}$ . …

Start your 14-day free trial to unlock the full solution →

←Previous question · evaluationQ14 — Obtain the equation for resultant intensity due to interference of lig…→Next question · evaluationQ16 — Obtain the equation for bandwidth in Young's double slit experiment.

Q.Explain the Young's double slit experimental setup and obtain the equation for path difference.

🎓Unlock everything free for 14 days

Unlock everything free for 14 days